[gitplayer]

Vor allem bei der Werbung:

http://www.cardone.com/Products/Prod...ductId=3174610

All electronic module components are 100% computer tested to ensure full functionality.
Automated test equipment verifies signal strength, correct polarity of wire harness, air gap, crank reluctor tooth size, as well as ignition coil and pickup performance
CARDONE uses the right gear hardness for the appropriate application. If the gear is too hard, it will damage the cam; if it's too soft, the gear itself will be damaged, potentially causing severe engine damage – possibly even engine failure. Many offshore manufacturers use one gear hardness without varying by application as O.E. designs do.
O.E. components with consistently high failure rates are 100% replaced or repaired to meet or exceed O.E. performance.
Precise machining tolerances prevent oil leakage, poor timing, setting of the "Check Engine" light, and premature failure.

Jaja, am Arsch! Trottel!