Hier steht, wie man das macht:
http://www.toyotacelicaonline.com/repair.htm#3sge
Zitat:
Setting the Throttle Position Sensor (TPS) on the 3S-GE
From messageboard, contributed by Quyen.
Quyen
Adjusting TPS...
Mon Apr 23 23:47:37 2001
I am assuming that you're working on your car, 3SGE.
1. loosen the two nuts on the TPS.
2. Put a 0.6mm feeler gauge between the throttle stop and stop lever.
3. Connect the ohmmeter to the bottom two terminals (IDL and E2).
4. Turn the sensor clockwise until the ohmmeter's needle moves. Tighten up the two
screws.
5. Replace the 0.6mm gauge with a 0.5mm, there should be continuity between IDL
and E2. Replace the 0.5mm gauge with a 0.7mm gauge, there should be no
continuity.
|