Einzelnen Beitrag anzeigen
Alt 04.10.2009, 00:10   #31
Alonso
Projektleiter
 
Benutzerbild von Alonso
 
Registriert seit: Aug 2004
Ort: CH-3072
Beiträge: 4.502
iTrader-Bewertung: (16)
Alonso wird schon bald berühmt werden Alonso wird schon bald berühmt werden
AW: 7M Leistungs Projekt

Zitat:
Zitat von Amtrack Beitrag anzeigen
Wenn man so schaut wie die Dragster laufen... die haben 90° Knicke und Winkel im Ansaugtrakt und haben dennoch ihre 8000PS Ladedruck wirds scho richten oder wie war das?
Zitat:
For example, in a piping system, if you have a 90-degree
bend, it has a specific loss coefficient associated with it. Again, quoting A.
Graham Bell, “To compensate for flow loss caused by bends, decrease
horsepower by 5% for each 90 ̊ bend. Keep in mind that three 30 ̊ bends
cause the same flow loss as a 90 ̊ bend.” To make a long lesson in fluid
dynamics short, this means that the fluid or gas flowing through this pipe has to expend (or more accurately, lose) a certain amount of energy to each change in direction it is undergoing. That loss is energy that your engine and turbocharger are producing that isn’t being utilized efficiently! You definitely do not want your turbocharger working harder than it needs to. Furthermore sharp bends, or complete right angle bends will have greater loss coefficients than would a smoother radius bend.
Kommt halt immer auf die Konstruktion an. Ob das Piping jetzt halt eine 90° Windung hat, oder eben das ganze verteillt wird auf 3x 30° spielt theoretisch gesehen keine Rolle. Es sollte lediglich auf jede unnötige Windung verzichtet werden. Daher kann das bestmöglichste Piping tatsächlich auch mal einen 90° Bogen haben - muss aber nicht
Alonso ist offline   Mit Zitat antworten